Installation Guide

Cut ledger to length and lay out joists.   
Temporarily attach the ledger in its desired location.   
     
Drill holes as specified by your designer. Avoid joist locations or vertical grooves in siding if applicable.
     
Remove ledger, center Deck2Wall Spacers� over bolt holes and attach with corrosion-resistant screws or nails to the building side of the ledger.
     
At the house, apply silicone sealant in and around the bolt hole to prevent moisture intrusion.
     
Position ledger into proper alignment on building and secure with appropriate fasteners.

When using Deck2Wall Spacers�, use appropriate fasteners for the specific application and conditions. Consult a design professional if necessary.